So proceed carefully, and with the advice of a contractor or engineer, if you plan on removing any interior walls to “open up” the floor plan. Some ceiling joists may also bear on those walls. If you remove any of those walls, the roof won't fail, but will likely sag over time. The only issue to consider when there are purlins in the attic is that there are interior walls directly below the base of the kickers that provide structural support through the kicker/purlin configuration to the rafters. But, if the purlins appear to be the same age as the rafters and professionally installed, it’s just because that was the way things were done back then. The beam running perpendicular to the rafters at approximately the midpoint between the top plate of the wall and the ridge board is called a “purlin," and the diagonal braces are “kickers.” The bottom of the kicker bears on an interior wall or beam below.īecause this is an old-fashioned construction style, sometimes homebuyers that see purlins in the attic think that the bracing has been added as a repair because the rafters were sagging or due to some other structural problem. It was a way to provide additional rafter support, and also some resistance to lateral movement, for longer-span roof rafter framing. We often see this detail in older homes built before manufactured roof trusses became the standard for residential construction.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |